Separate names with a comma.
Some features disabled for guests. Register Today.
Hello, I just finished assembling my Lead 1010, OpenBuilds everything - BlackBox, power supply, etc. When I jog the machine with the Interface, X...
Just assembled my new OpenBuilds 1010 LEAD and have loaded a simple GCODE (lizard from the OpenBuilds library) and every time I attempt to run the...
Hello I plan on making guitar bodies on my Lead 1010 but now I am not sure if it will work? Anyone done this here? The stock needs to be 1.75" -...
I am new and already surfaced my spoilboard. My next adventure is to put holes in my spoilboard. Before I do that I created just a one hole gcode...
Just getting to the end of my 1010 build and i noticed a fare amount of play in my Z axis. I have the little clip attached, hoping someone could...
Hi guys, Let's see if anyone could solve this question. As far as I know the standard Workbee has a limited workable height of 47mm, Instead of...
I learned from another thread here that one could invert the axis front to back, and make the axis travel a greater distance. Well, I took the...
needed a floating Z for my plasma table build found one on another site remixed it to suit openbuilds C gantry plate Ive supplied stp and...
Hi sorry if most or all of this has been covered but looking at possibly upgrading my Lead 1010 1. Raise x gantry to gain another 1" or 2" in Z...
Hello, I have been using the CNC xPro v4 for a few months now with the ACRO system build and it has worked great. However, I recently have tried...
Powered up my new Blackbox today, My first CNC controller. I connected my 3 stepper motors to do the first test. Went trough the setting page and...
I recently bought a C beam CNC machine with 3 axes (c beam linear actuators). I am planning to attach an additional linear actuator to my z axis...
:(hi all I’m after a bit of help. I’ve made a combined edge probe and touch plate for my cnc. Connected the positive to the plate and negative to...
I am sorry if this has been asked a thousand times, but I have spent several hours trying to navigate the site and really can't find an answer to...
I have the ox cnc machine, how accurate can I expect the Z axis to be? and how do I calibrate it? when I run a job the first cut always seems to...
Hi everybody, I bought CNC xPRO Controller V2 on August 2015. Since then, I made a CNC router. I use Universal G Code Sender to drive my motors....
Hello everyone, I am facing a strange problem on my DIY CNC project. I can move every axis one by one, without any unexpected bahaviour, but when...
Hi all. I'm getting ready to build an OX and would like to know if anyone has built a longer Z axis. I would like to add more height to mine...
