Separate names with a comma.
Some features disabled for guests. Register Today.
I have a WorkBee from China (Bulkman3d) and it is assembled. My Stepper motors have never worked, I thought it may be the software I was...
Hi there, Was hoping someone might be kind enough to have a look at these 2 short videos and see if the sound is unusually loud to you please?...
Dear Openbuilders, I have a pan tilt head with two nema 17 stepper motors. I like to use them for a differnt porpous. Unfortuntaly they don’t have...
I've been having some trouble with my half-width Lead 1010 (so is that a Lead 1005? Lead 0510? Lead 1010/2? Eric the Half-A-Lead?) lately, and...
Good evening! I've just put together my Black Box, changing from a xPRO V4. - Wired the motors according to the setup instructions: * A+ = Red *...
I am building a cnc router with dual x and dual y stepper motors these steppers are nema 17 with 84 oz.in torque. Can the BlackBox Motion Control...
Short version: Halp! Mah Z dun wurk rite! Long version: So I've got my half-width LEAD 1010 together (Lead 0510? 1005? Eric the half a LEAD?),...
[ATTACH] With new tech comes exciting new prospects and goals: An Ecosystem, not just a product: The new system evolved around a set of...
Hi I built one of the Ooznest OX CNC machines from a kit. Running 4pcs. NEMA 23HD56001Y steppers. So I sat up an Arduino with a CNC v3 shield and...
Just sorting my electronics for my 1000 x 1000 Sphinx Laptop —-> Arduino —-> DQ542MA —-> Nema 23 (265 oz) First off thanks for a superb...
Hello OpenBuilds posters ! We are working on a school project using 4 stepper motors and drivers, we have four 14HS11-1004S (Nema 14 Bipolar...
I purchased 3 stepper controllers that have dip switches which allow me to regulate the amps. https://www.pinterest.com/pin/620511654881622915/...
Hey all, Total stepper newb so looking for some help here. Having trouble with my stepper motor project. I'm using: Wanta DQ542MA 2H Microstep...
I've purchased four brand new, never used, not even wired up Nema 23 Stepper motors (~$25). What I needed were the High Torque Series Nema 23...
Hello everyone, I've been developing a hbot machine for a while now and I'm having problems with my electronics. Specifically, my xy motors that...
Hi, I have access to an old CNC router that uses HY200 3424 stepper motors (NEMA 34); see link below to pdf. They are rated 4.7 A, 90 Volt and...
.9deg Nema 23 Stepper Bipolar 2.8A 1.26Nm(178.5oz.in) 23HM22-2804S|23HM22-2804S|Nema 23 Stepper Motors This NEMA 23 appears to have the same...
