Separate names with a comma.
Some features disabled for guests. Register Today.
Hi all, I'm looking to build a CoreXY, and really thinking of going with the LayerFused X301 design with its 300x300 heated bed. I've found a...
Hi there! Is there an off the shelf bracket I can use to mount the stepper motor underneath the C beam of the C beam linear actuator, connect it...
Hello, Sorry if this is the wrong place to post this question. Also apologize for how basic my Qs are, this is my first time working with this...
A common request for help starts "My steppers make a noise, but don't turn" Those symptoms are exactly what you would expect if the motors are...
Hi All, I have an Acro 1510 that I recently set up and the steppers get quite hot after an hour of use. How hot? >> about as hot as a mug...
Arduino based build with TB6600 drivers and NEMA 23's. I finally got some motion on my machine, but when I prompt it to jog in UGS, the motors...
Hey guys, let me start saying that I'm a total newbie in electronics and CNC machines. I'm building a CNC laser cutter. I'm using Chinese...
Hi All. I am doing a project for Remote Control Pan-Tilt for DSLR Camera. Attached is the Module I made using 2 NEMA-17 14:1 Stepper Motor. The...
Looking for suggestions on how to identify the exact position of the gantry plate on a C-BEAM linear rail with millimeter accuracy. Not sure if...
Hello OpenBuilds posters ! We are working on a school project using 4 stepper motors and drivers, we have four 14HS11-1004S (Nema 14 Bipolar...
I recently bought and assembled the C-Beam machine. I took it outside to do first cuts earlier this morning and much fo my dismay ended up with...
Hi all, this is my first time setting up a CNC router. I have the OX CNC with Nema23 steppers and the CNC shield paired to GRBL running V1.1....
Hi, New to CNC machines. Making a 3 axis cnc using Nema 34. Can someone recommend a suitable free software to use? Thank you
I've purchased four brand new, never used, not even wired up Nema 23 Stepper motors (~$25). What I needed were the High Torque Series Nema 23...
Hello everyone, I've been developing a hbot machine for a while now and I'm having problems with my electronics. Specifically, my xy motors that...
Hi ... I'm trying to design my first CNC router with ballscrew on Y axis ... roughly 50 x 50cm cutting area. 1. Everybody seems to use 2...
Hello, Your typical newb here asking a fairly newb question. I did a couple searches and maybe I did not use the correct search terms, but I...
Hi guys, this looks like a lot of fun. I found grbl and tinyg after watching NYC CNC on youtube and I'm excited to get mine working. Question is...
I'm working on designing and building my first CNC router. As I am not a mechanical engineer nor have I much experience with building (apart from...