Separate names with a comma.
Some features disabled for guests. Register Today.
I'm new to grbl. I need a basic two axis setup with two motors per axis. I'm not sure if grbl even allows it as its a 3 axis only solution as per...
Hello, I've built a Dremel CNC. According to the guidance of Nikodem Bratnik. The problem is that the stepper motors make a rattling noise, but...
Hi, I can flash GRBL 0.9 to my xPRO just fine. In fact it has had that on it for 2-3 years, and flashing it again works fine. Now I want to try...
Hey everyone, I was wondering if anyone knew how to use python to prompt Grbl for its current position (x,y,z)? The goal is to send all my...
[ATTACH] Hello Open Builds Community! I'm the lead developer of the Grbl CNC project, which is the firmware that runs most of the...