Separate names with a comma.
Some features disabled for guests. Register Today.
Hello Everyone, I'm new to the CNC world after recently building a Rat Rig Stronghold One (750x750). I've been learning/testing for a few weeks...
I have been using a stock manufactured 24" x 24" cnc for sometime now and was looking at fixing a few components and selling it off after I build...
What are the steps/requirements to get the Openbuilds Blackbox X32 to mount and access a SD card using CONTROL? I've read the various posts about...
Hi I made the choice to buy a Vevor evaluation 4 8080 cnc machine and found out after the fact that the guy had broken it before selling it to me....
I've just built a RatRig Stronghold one 1250 x 1250 and and managed to get the "hello world" example done last night. I have the AMB CNC Spindle...
I was doing a Y axis calibration. I had exact numbers from a piece that I machined so rather than going through the wizard procedure I calculated...
Hi, I just update BlackBox x32 with new firmware with OpenBuilds CONTROL v1.0.370. After Update Log / Serial Console detects board: Firmware...
Hello! I have my high torque openbuilds stepper motor wired up like the diagram below. I just have x axis wired up for testing. I turned on the...
I am trying to achieve stepper speeds between 1 and 100 mm/hour using the BlackBox 32 and a nema23 stepper motor. I contacted open builds and they...
Hello. I have just finished my Lead1515. I'm using these motors:...
Hey all, Can someone help me figure out why my x-limit switch is being triggered? I have switched the endstop and switched it around with the...
I recently bought the new X32 black box and after going through all the steps and updates finally got it to work with the Interface. My interface...
Hey all, I have an Estop wired up to the door stop and the light is lit on the blackbox unit and also turns off when I press the button, but in...
I recently purchased the Openbuilds Blackbox X32 after previously using the original Blackbox. I have simply replaced the plugs from one...
