Made this after my wife saw one on Pinterest. Made it from oak. Used drawer pull handles from Home Depot. Did the major design in Sketchup and the lettering in Inkscape. Created the Gcode for the tray in Meshcam and the lettering in F-Engrave. Used the OpenBuilds Control for GCode sending.
- Machine Type:
- OpenBuilds LEAD Machine
- Software:
- Sketchup, F-Engrave and Openbuilds Control
- Electronics:
- OpenBuilds BlackBox
- Bit or Laser Size:
- 1/4" flat end mill for shot holes and roughing, 90 degree 3/8" V bit for carving
- Materials:
- Oak
-
Dismiss NoticeThis site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
User Comments
Sort Comments By