hi kyo, i ran into a problem with grbl, i'm not sure if soft ware is causing this all red lights on stepper motor driver go on when i plug in usb cable i did not setup grbl yet. before i hooked up "a" on board, xyz motors did jog, the " a" motor is also ok, but not working. this is a sphinx build if this is settings is it possibal to get right settings as i will be using this for carving i am using dq542ma steppers and phoenix control board . thank you
The red lights usually indicates $4 is set incorrectly in Grbl settings, refer to Spark-Concepts/xPRO $4=1 (step enable invert, bool) (Board V1, V2, V3 Matte = $4=0 - Glossy board V3 = $4=1)
thank you peter i will do change as soon as i get ob machine driver working. i can't seem to get driver for com port to install.