Welcome to Our Community

Some features disabled for guests. Register Today.

GrayUK
Last Activity:
Oct 22, 2017 at 10:16 PM
Joined:
May 5, 2014
Messages:
1,022
Likes Received:
279
Trophy Points:
83
Resources:
1
Gender:
Male
Birthday:
Nov 6, 1949 (Age: 67)
Location:
Dorset England
Occupation:
Driver

Share This Page

GrayUK

Master, Male, 67, from Dorset England

Staff Member Moderator Builder
GrayUK was last seen:
Oct 22, 2017 at 10:16 PM
    1. Kelvin Qdos
      Kelvin Qdos
      Hi Gray,

      I just joined Openbuilds and on my first scurry around the site your name popped up strait away. Given that we're both in Dorset I thought it rude for me not to say hello.

      I joined basically as I figured it was time to set too and build a CNC and a 3D printer and this site seems to be right up my street.
      1. GrayUK likes this.
    2. Gonçalo martins
      Gonçalo martins
      Good Morning,
      Sorry to be bothering but I have a problem with my cnc:

      He is using Arduino one and G-shield, and Universal G sender

      It works well with the G sender manually on the various axes, however when
      Sending a project to cut it advances in x + and gets uncontrolled.

      Or rather loses the coordinates.

      I really do not know what I'm doing wrong.

      Someone who can help me.
      1. GrayUK
        GrayUK
        Hi Goncalo
        As I have previously written below, I'm afraid I am more conversant with the mechanical side of CNCs rather than the electronics. I think you will be much better off starting a thread in the General Area of the Forum, rather than within my own Profile.
        Sorry I can't be of more help.
        Gray
        Jul 7, 2017
    3. Robert Davis
      Robert Davis
      Hi. I am an old cogger who is new to this. I may be in the wrong place so if I am perhaps you could point me in the right direction.
      Just purchased a Mini Mill and have completed putting it together. Now I need some help with the electronics and computer software.
      I am well used to drawing in solidworks so now I need to be able to connect my drawings to the mill. It is this I think I need help with
      1. GrayUK
        GrayUK
        Hi Robert.
        I'm afraid I am more conversant with the mechanical side of CNCs rather than the electronics. I think you will be much better off starting a thread in the General Area of the Forum, rather than within my own Profile.
        Sorry I can't be of more help.
        Gray
        Jun 14, 2017
      2. crispin
        crispin
        Sep 6, 2017
  • Loading...
  • Loading...
  • About

    Gender:
    Male
    Birthday:
    Nov 6, 1949 (Age: 67)
    Location:
    Dorset England
    Occupation:
    Driver
  • Loading...
  • loading...