Welcome to Our Community

Some features disabled for guests. Register Today.



Table Up - Back

NLucier, May 19, 2017
crispin likes this.
    • Alex krause
      This gives me a great start for building an automated panel saw thanks for sharing
    • NLucier
      No problem. Basically I used the V-slot to make a shelf attached to the wall using the Openbuilds Masterlink hardware for joints. It is 1500mm long, 500mm deep, 500mm tall w/ 3 diagonal braces to hold the top level. The router frame is attached to the front of the shelf using a heavy duty piano hinge. The thing is rock solid. I still need to make the legs for the front to rest on, currently it is using a sawhorse that happened to be the exact height to the floor. The shelf top MDF piece also acts as a rigidity device and a handy place to put the power supply and other stuff. The only thing I have to remember is to move the gantry all the way to the back before lifting it up.
    • Daniel Harbin
      Do ya think the y and z axis will come out of alignment when flipping the machine? Its hard to tell from the pic if it is a machine that folds up or if its a slightly vertical in operation.
    There are no comments to display.
  • Album:
    CNC Router
    Uploaded By:
    May 19, 2017
    View Count:
    Comment Count:

    EXIF Data

    File Size:
    5 MB
    Mime Type:
    LG Electronics
    Date / Time:
    2017:03:19 23:57:24
    Exposure Time:
    1/30 sec
    ISO Speed Rating:
    ISO 200
    Focal Length:
    4.17 mm

    Note: EXIF data is stored on valid file types when a photo is uploaded. The photo may have been manipulated since upload (rotated, flipped, cropped etc).

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice