Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Vectric and Openbuilds

Discussion in 'OpenBuilds Forum Help' started by ricklach, Oct 2, 2019.

  1. ricklach

    ricklach Well-Known
    Builder

    Joined:
    Aug 26, 2019
    Messages:
    121
    Likes Received:
    17
    In Vectric Cut2D pro there is an option to select the post processor. Which one should be selected for an Workbee 1510?
     
    #1 ricklach, Oct 2, 2019
  2. sharmstr

    sharmstr OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 23, 2018
    Messages:
    2,039
    Likes Received:
    1,434
    Depends on your controller. I'm going to assume its grbl based so pick grbl-mm. You might have to remove the tool call depending on what gcode sender you are using. I've never used Cut2D so not sure how similar it is the vCarve, but his might help you at some point:

    VCarve OB friendly post processor: https://openbuilds.com/threads/vcarve-grbl-post-processor-mods.14580/
     
    #2 sharmstr, Oct 2, 2019
    Peter Van Der Walt likes this.
  3. ricklach

    ricklach Well-Known
    Builder

    Joined:
    Aug 26, 2019
    Messages:
    121
    Likes Received:
    17
    I have the blackbox processor. I checked the post processor list and it has grbl (in) and Grbl (mm) so I will give those a try.
     
    #3 ricklach, Oct 3, 2019
    sharmstr likes this.
  4. sharmstr

    sharmstr OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 23, 2018
    Messages:
    2,039
    Likes Received:
    1,434
    Yep, those are the ones.
     
    #4 sharmstr, Oct 3, 2019

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice