Welcome to Our Community

Some features disabled for guests. Register Today.

      1. Build Progress:
        • Build in Progress...
      Rate This Build
      0/5,
      0 votes
      Originally I wanted to cut 400 x 400 but after working out all the sizes and what I could get out of the lengths of c-beam and leadscrews it was around the same cost to go for 480 x 580 build area.

      So far I have done a moch-up with printed parts so I can make any changes extra holes etc before I get the plates cut.

      Not sure on control yet but im leaning towards Bcnc and arduino.
      Michael.M, Mark Carew and Kyo like this.
  • Loading...
  • Build Details

    Build License:
    • CC - Attribution Share Alike - CC BY SA

    Inspired by

    Kyo's Sphinx
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice