Build List
-
Active Filters:
mega
Build Author Corey Corbin Views 3789
Sphinx Derived Router
I Like the Sphinx design thought I would attempt my first build. I wanted to build this and use Arduino controller with GRBL to be able to learn and understand my machine.
Build Author JerwanDavis Views 4870
Coined by my family as the: Davomatic
Build Notes: Here are all the parts necessary to re-produce this design. Please note, all of the parts are either sourced through openbuilds or have been selected and printed from thingiverse.
Build Author mirage335 Views 6444
TazStiff
Portable, high-speed, low-cost advanced multi-tool desktop factory derived from LulzBot Taz and TazMega.
Build Author Keteland Views 9769
MULIMATERIAL 3D PRINTER (in progress)
ELECTRONICS - ARDUINO Mega 2560 + RAMPS 1.4 + power supply 12V - Leadshine DM 5042 external driver + Power supply 36V + NEMA 23 stepper motor SOFTWARE - Repetier Host to communicate with the Ramps - ARDUINO to upload the firmware (Marlin) MECANIC - V-Slots rails 40x40 + home-made plates - everything goes fine on the side of the build
Build Author Anglesachse Views 8105
Zorkbot
Corexy, with possible head change (3d, cnc, laser)
Build Author Gerrald Views 4658
Pong CNC
This build is to show what's possible as well with openBuilds! I use a single ArduinoMega and 5 separate stepper drivers (A4988). The LEDs are all NeoPixels. Collision 'detection' is all done within the code, so the endstops are only sensors I use in this build. I'm a self-employed video-artist and this is my first installation which just needs power and it runs (where I'm quite proud of). Normally my interactive installations take a long setup time, so this installation is a relief :)