Generic 6 Axis CNC Controller
Up to 3 Linear-axis and 3 Rotational Axis. Pinout see UB1 and UC300ETH documentation.
UC300 plugged into UB1 driving the Stepper Drivers and receiving the Limit and other Switches.
Tested with UCCNC and Mach 4 Controller Software
Requires a PC to install the controller Software, connected via Crossover LAN Cable
Raspberry 3 on board with bCNC directly installed, driving the Linear-axis (XYZ) through the Protoneer Raspberry CNC Hat. In this configuration, the PC, UC300ETH and UB1 are not required but the Limit are 4 Linear-axis
For Details see my Homepage.
Generic 6 Axis Controller
Generic 6 Axis (Stepper) Controller
- Build License:
- CC - Attribution - CC BY
Reason for this BuildWanted a generic CNC Controller to drive up to 6 Axis on Stepper Motors, 5 Homing/Limit Switches, a 0-5V output for Spindle Control and a Probe and E-Stop Input line.