Welcome to Our Community

Some features disabled for guests. Register Today.

Workbee 1510 Z axis stalls on up motion

Discussion in 'CNC Mills/Routers' started by thehawkeye8six, Feb 21, 2019.

  1. thehawkeye8six


    Jan 31, 2019
    Likes Received:
    Moving 1mm at a time is fine but as soon as it goes over that it stalls and doesn't move up all the way, because of this it losses its proper z axis possition and dives to deep into material. Any Ideas?

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice