Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Want to change to inch from mm in CAM Gcode Creator

Discussion in 'Control Software' started by Steven Small, Aug 30, 2019.

  1. Steven Small

    Steven Small New
    Builder

    Joined:
    Aug 1, 2019
    Messages:
    1
    Likes Received:
    0
    Is it possible to change the X, Y, and Z from mm to inch in the CAM Gcode Creator.
     
    #1 Steven Small, Aug 30, 2019
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    14,749
    Likes Received:
    4,264
    CAM is Metric only at this time, but with so few entries easy enough to do a little multiplication, or a lookup table. 1/8th endmill, 3.175mm. Etc

    Otherwise consider one of the non-free alternatives
     
    #2 Peter Van Der Walt, Aug 30, 2019

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice