Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Plasma table Touch off - HELP!!!

Discussion in 'OpenBuilds Forum Help' started by BrandonLebrun, Mar 20, 2024.

Tags:
  1. BrandonLebrun

    BrandonLebrun New
    Builder

    Joined:
    Jan 21, 2024
    Messages:
    8
    Likes Received:
    1
    Hello Everyone,
    I'm Back!! I have learned a lot since my last post. Except how to set up touch off on my plasma table. I have searched (what i think) high and low but can't seem to find answers to the questions i have. I installed the limit switch on my floating head but that's as far as I've gotten. I'm not sure what/how/where to do the rest. Is it in fusion 360, OB Control, GRBL settings or the gods of plasma cutting. I'm sure I have settings to enter somewhere but don't know where or how. I'm sure I'm not asking the right questions when I search it. I'm using OB X32 motion controller. Please help this old guy out! TIA!!
     
    #1 BrandonLebrun, Mar 20, 2024
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    14,428
    Likes Received:
    4,197
    #2 Peter Van Der Walt, Mar 21, 2024
  3. BrandonLebrun

    BrandonLebrun New
    Builder

    Joined:
    Jan 21, 2024
    Messages:
    8
    Likes Received:
    1
    Thanks Peter! It worked perfectly! I appreciate it very much.
     
    #3 BrandonLebrun, Mar 23, 2024

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice