Welcome to Our Community

Some features disabled for guests. Register Today.

Openbuilds XYZ Probe

Discussion in 'Other Builds' started by abello, May 3, 2022.

  1. abello

    abello New
    Builder

    Joined:
    Apr 29, 2022
    Messages:
    3
    Likes Received:
    0
    X and Y jogs sometimes stop early (before touching the probe). This happens whether I'm doing XYZ or just a single axis. After it happened the first time when I was testing a single axis I jogged real close to the plate to make sure it would touch it. For the xyz I'm at the mercy of whatever is happening. Probably a setting I have missed...?

    Thank you,
    AB
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice