Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

No movement on 4th (a) axis but display in mach 3 says different

Discussion in 'CNC Mills/Routers' started by jason vaughan Lewis, Jan 14, 2019.

  1. jason vaughan Lewis

    jason vaughan Lewis New
    Builder

    Joined:
    Jan 14, 2019
    Messages:
    1
    Likes Received:
    0
    I am trying to setup my 4th axis. Ive got a mkx breakout board which works fine. the issue is that on mach3, the a axis movement is seen, but no movement on the actual stepper. ive tried using the slave setting to make sure the signal is getting to the driver etc and it does. in slave mode, it mirrors exactly. im at the end of my tether. can anyone hrelp? Thanks in advance. jay
     
    #1 jason vaughan Lewis, Jan 14, 2019

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice