Welcome to Our Community

Some features disabled for guests. Register Today.

Need WorkBee Front and Back Plates

Discussion in 'Share Parts' started by thatguypeter, Jun 8, 2019.

  1. thatguypeter

    thatguypeter Journeyman
    Builder

    Joined:
    Jan 28, 2019
    Messages:
    43
    Likes Received:
    12
    Des anyone have the WorkBee Front and Back X axis plates? I looked in the parts file and they are not available for the public. I can't find these plates anywhere except to buy the whole WorkBee Plates system. I just need these two plates to upgrade my own CNC Machine build.

    Any help would be much appreciated,

    Peter
     
  2. sharmstr

    sharmstr Master
    Moderator Builder

    Joined:
    Mar 23, 2018
    Messages:
    827
    Likes Received:
    460
  3. Chadfarmer

    Chadfarmer Journeyman
    Builder

    Joined:
    Feb 13, 2019
    Messages:
    87
    Likes Received:
    1
    I have the whole kit minus the z plates

    100 shipped if u want. I used them maybe 5 hours before tearing off and starting over. Mine are off a 1510 if that helps
     
  4. thatguypeter

    thatguypeter Journeyman
    Builder

    Joined:
    Jan 28, 2019
    Messages:
    43
    Likes Received:
    12
    Thanks for the offer, but I am going to be cutting them out using my CNC machine. I just needed the design since I have a lot of scraps 6061 laying round..
     
  5. Chadfarmer

    Chadfarmer Journeyman
    Builder

    Joined:
    Feb 13, 2019
    Messages:
    87
    Likes Received:
    1
    No problem atleast u can get it done.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice