Welcome to Our Community

Some features disabled for guests. Register Today.

Moons Stepping motors 17HD4063-06N

Discussion in 'Motors' started by jeffmorris, Jan 20, 2018.

  1. jeffmorris

    jeffmorris Journeyman
    Builder

    Joined:
    Nov 6, 2017
    Messages:
    481
    Likes Received:
    112
    I took these motors from a 3D printer that broke down and used them on a new machine based on ARCO system, 24VDC PSU, and CNC xPro controller. Using GRBL Panel software, I can jog the motors but they run HOT! I set the motor setting trim pots about a quarter turn from left. How can I fix the problem? The micro-steps are set at 8x.
     
  2. Gary Caruso

    Gary Caruso OpenBuilds Volunteer
    Staff Member Moderator Builder

    Joined:
    May 19, 2016
    Messages:
    1,184
    Likes Received:
    531
    Reduce the current some more.. how hot?
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice