Welcome to Our Community

Some features disabled for guests. Register Today.

Lead 1010 CNC Controller Stepper Driver Not Working

Discussion in 'Controller Boards' started by Trooper11040, Dec 11, 2018.

  1. Trooper11040

    Trooper11040 Journeyman
    Builder

    Joined:
    Nov 23, 2018
    Messages:
    38
    Likes Received:
    18
    Just finished the build of my lead 1010CNC...everything is plugged in, I had power to the motors this morning. Went to finish zip tying all the wires/cables and now I have power to the board, but no power to any stepper motor...anything I should be checking? Thanks!

    Dan
     
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Resident Builder Project Maker Builder

    Joined:
    Mar 1, 2017
    Messages:
    1,388
    Likes Received:
    736
    Just FYI - this thread is resolved over on OpenBuilds CONTROL Software :) - future reference for others, check $4=1 in your grbl settings
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice