Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

iot relay will not shut off

Discussion in 'General Talk' started by bubbatay, Mar 20, 2024.

  1. bubbatay

    bubbatay New
    Builder

    Joined:
    Jan 21, 2021
    Messages:
    3
    Likes Received:
    0
    I am using a iot relay with my xcarve 1000 x 1000. When I start a project the router starts fine but when the carve is complete the router does not shut off. is there a grbl setting i should be looking
     
    #1 bubbatay, Mar 20, 2024
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    14,881
    Likes Received:
    4,285
    Does your gcode contain a spindle off command at the end?

    Is the IoT wired to Tool Enable or Tool PWM?

    Is it a BlackBox or some other controller?
     
    #2 Peter Van Der Walt, Mar 20, 2024

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice