Hey guys, just got a new acro 55 an threw an optlaser on it. Using the blackbox with limit switches and they work great. My machine homes to the front left side, but whenever I try to check the size or run a job, the machine sends the X axis to the right and crashes the Y into the limit switch. Any ideas on what is wrong?
Did you remember to SETZERO at the bottom, left too? Everything moves relative to Work Coordinates - not machine coordinates. Refer to github.com/gnea/grbl/wiki
and make sure your tool movement directions are correct... https://openbuilds.com/attachments/workbee_1510-axis-directions-png.44062/
