Welcome to Our Community

Some features disabled for guests. Register Today.

Hobby-fab controller

Discussion in 'General Talk' started by Michael Fischer, May 27, 2019.

  1. Michael Fischer

    Builder

    Joined:
    May 27, 2019
    Messages:
    2
    Likes Received:
    0
    Hello all. Does anyone have experience with the hobby-fab CNC machine? I'm new to using CNC. As a matter of fact I haven't yet used the machine my wife bought. She bought a Hobby-fab OX machine (Second person), but I cant seem to get it to respond to the software interface. Does anyone have experience with the Hobby-fab control board? I checked all connections for continuity, but when I try to home it gives an error. any ideas, or if you've seen a posting please share. I've perused a lot of sites looking for hints.
     
  2. Christian James

    Christian James Journeyman
    Builder

    Joined:
    Jun 8, 2018
    Messages:
    434
    Likes Received:
    210
  3. Michael Fischer

    Builder

    Joined:
    May 27, 2019
    Messages:
    2
    Likes Received:
    0
    Thanks Christian, but unfortunately no; however, I am saving this link for when I get the CNC machine working overall and I'm ready to attach a laser. I think the control board is bad, but haven't been able to find anything describing how to check.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice