Welcome to Our Community

Some features disabled for guests. Register Today.

H Bot Motor config

Discussion in 'Motors' started by Jrocket9779, Feb 5, 2019.

Tags:
  1. Jrocket9779

    Builder

    Joined:
    Feb 4, 2019
    Messages:
    1
    Likes Received:
    0
    I’m at the end of my build , large H Bot. 350x350x700. I have tried everything I can think of to wire the x and y motors. All I get is loud hissing sounds and some stuff wrong movements. Does anyone have the proper pinout guide for this?
     

    Attached Files:

  2. Ariel Yahni

    Ariel Yahni OpenBuilds Team
    Staff Member Project Maker Builder

    Joined:
    Oct 22, 2015
    Messages:
    111
    Likes Received:
    359
    Do you mean wire them to the board? Or the Config?
    Have you told the firmware this is and HBOT ?
    If they sound funny, without moving its either wrong polarity on steppers, POT to low or high, wrong config on firmware
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice