Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Gantry just stops in the middle of a carve

Discussion in 'OpenBuilds Forum Help' started by William K. Brady, Nov 6, 2023.

Thread Status:
Not open for further replies.
  1. William K. Brady

    William K. Brady New
    Builder

    Joined:
    Jan 4, 2023
    Messages:
    2
    Likes Received:
    0
    MY machine is experiencing a problem that I can not seem to resolve. Gantry just stops in the middle of a carve. All my wiring is good. Latest firmware is installed. I home the machine and that works great. I load up a file and it starts carving perfect. Then at random spots it just stops moving. Router keeps spinning. It has never done this before. Gives me an alarm 1 error. If anyone knows of a fix for this I would appreciate it.
     
    #1 William K. Brady, Nov 6, 2023
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    14,867
    Likes Received:
    4,283
    Please note our support team has responded to your earlier ticket about the same issue. Thanks
     
    #2 Peter Van Der Walt, Nov 6, 2023
Thread Status:
Not open for further replies.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice