Hi everybody, I (not frequently) use Fusion to apply CAM. I have a problem with contour 2d: I use a 6 mm end mill on my workbee 1510. I select in Fusion the bottom contour of the model adding tabs and multiple depths of 3mm. When I simulate the path, it goes backward! It starts from the bottom and goes up to the top...whyyyyyyyy? i'm getting crazy. I here add some screen shots: thank you for your time and help. Macs
The screen shots are too low resolution to be able to read. Can you post the F360 file (*.f3d) and I will take a look.
Ha ha! That was easier than I thought - I didn't really need the file: You have the simulation running backwards! You see the dot on the slider under the 'play' controls? Drag that to the right of centre and it will run forwards again. (For what it is worth, the simulation ran OK for me.)
