Welcome to Our Community

Some features disabled for guests. Register Today.

Duet3d and endurance lasers

Discussion in 'Laser Cutters' started by Rob Atha, Jun 17, 2020.

  1. Rob Atha

    Rob Atha New
    Builder

    Joined:
    Aug 19, 2018
    Messages:
    53
    Likes Received:
    7
    Hi all,

    I recently had to change from my xpro v4 to a Duet3d board after the xpro developed a fault with the probe and the pwm signals.

    anyway I want to get my endurance laser working on this board, but not sure how to go about it. I’ve seen some technical stuff but I’m not that intelligent when it comes to this stuff, does anyone know any simple guides or videos out there that can help?

    Also I used to use light burn but as yet this isn’t supporting the Duet3d, can anyone recommend some software (preferably free) that I could use to export the gcode?
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice