Welcome to Our Community

Some features disabled for guests. Register Today.

cbeam vpro v2.0 and high torque motors.

Discussion in 'Controller Boards' started by greg winslow, Mar 18, 2019.

  1. greg winslow

    Builder

    Joined:
    Mar 17, 2019
    Messages:
    12
    Likes Received:
    1
    I ordered a cbeam kit and selected the nema 23 high torque motors with the kit. when I wired the motors to the xpro v3 board the motors will not move and the board has a red and yellow led on on each motor output. Do I need to get the
     
  2. Gary Caruso

    Gary Caruso OpenBuilds Volunteer
    Staff Member Moderator Builder

    Joined:
    May 19, 2016
    Messages:
    1,184
    Likes Received:
    531
    Make sure the coil wires are paired up, don't assume the wire color means anything.
    Also make sure in GRBL the $4=1 not default 0
    Gary
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice