Welcome to Our Community

Some features disabled for guests. Register Today.

C-Beam Prefab Untitled

Discussion in 'CNC Mills/Routers' started by ahayden, Sep 24, 2016.

  1. Rick 2.0

    Rick 2.0 OpenBuilds Team
    Staff Member Moderator Resident Builder Builder

    Joined:
    Dec 20, 2013
    Messages:
    2,262
    Likes Received:
    1,109
    No nut. The plates are threaded.
     
  2. eglin

    eglin New
    Builder

    Joined:
    Feb 19, 2017
    Messages:
    10
    Likes Received:
    0
    Yes, thank you for all the help. I actually did finish all the wheel/plate assemblies and everything made sense once I started building them. I am just going to mount all parts together now. I am curious about stop switches, how many do I need and where should I place them ? I didn't see any of the builds mention stop switches. Are the motors or drivers capable of detecting when it hits an end or does every corner need a stop switch?
     
  3. eglin

    eglin New
    Builder

    Joined:
    Feb 19, 2017
    Messages:
    10
    Likes Received:
    0
    I actually have everything wired up and need one last help, am I supposed to wire both x axis motors to the same output or can I control them together through different outputs?
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice