Welcome to Our Community

Some features disabled for guests. Register Today.

BlackBox vs Duet

Discussion in 'CNC Mills/Routers' started by RV6APilot, Jun 8, 2019.

  1. RV6APilot

    RV6APilot Journeyman
    Builder

    Joined:
    Apr 23, 2019
    Messages:
    30
    Likes Received:
    22
    So I mostly see people talking about how great the Duet controller is but very little about the BlackBox.
    I found the BlackBox very easy to build and connect and the software is easy to use as well. One thing
    that I saw recently was the Duet has the ability to pause and restart a job both from unintended power
    outages and on command. Is this something the BlackBox could do? Has anyone done a comparison
    of the 2?
     
  2. Alex Chambers

    Alex Chambers Master
    Moderator Builder

    Joined:
    Nov 1, 2018
    Messages:
    844
    Likes Received:
    437
    See this thread also; Blackbox vs Duet Wifi for Lead CNC
    There wasn't an enormous response - apart from anything else the Duet has only recently been used for cnc, so there are (relatively) few Duet/cnc users out there.
    Alex.:)
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice