Welcome to Our Community

Some features disabled for guests. Register Today.

BlackBox home position issue.

Discussion in 'Controller Boards' started by BillyBob, Jun 27, 2019.

  1. BillyBob

    BillyBob Well-Known
    Builder

    Joined:
    Nov 23, 2016
    Messages:
    21
    Likes Received:
    3
    When doing dry runs of the "hello world" file, all appears to go as it should. Jogging X, Y or Z axis is fine and smooth... HOWEVER, when I move the X and Y to the far corner of the table, then try to have them return the home 0,0 the Y seems to stall and stop, yet running the Y alone is not an issue.

    This is a router table using Y and Y slave.

    Any suggestions as to what I am doing wrong?

    Thanks
    Bob
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice