Blackbox controller 3D View shows phantom start/end move (green)

I recently did a carve where I set the origin in the near the center of a hollow deep carving. Because I could not lift the bit high enough to clear the surrounding material, I did not want the bit to leave the middle of the carving. The 3D Viewer showed a phantom move to the (0,0) (lower left/bottom) which scared me. I checked the g-code editor (very nice feature, by the way) and searched the beginning and end g-code and did not see this movement. Due the the large size I did not search all of it. I have tried to attach an image below of the job. I successfully ran the job and the movement did not happen, but I found it very disconcerting....

 

No, it started with:

T1
G17
G21
G90
G0Z2.000
G0X350.000Y350.000
M3S19000
G4 P1.8
G0X491.565Y384.661Z2.000

and finished with:

G1X492.715Y389.531
G0Z2.000
M5
G0Z2.000
G0X350.000Y350.000
M2

Preview

I have put the gcode, VCarve preview and OpenBuildsControl preview in the OneDrive folder above.