Welcome to Our Community

Some features disabled for guests. Register Today.

advice needed 7510 workbee

Discussion in 'CNC Mills/Routers' started by tankproof2, Nov 26, 2020.

  1. tankproof2


    Nov 26, 2020
    Likes Received:
    Hi guys, i dont know if this is the right place to ask this but could i have some advice on my first build.

    i am planning to buy a 750x1000mm mechanical kit off of ali express (https://www.aliexpress.com/item/3291...c00pATS93&mp=1) only because i think its the cheapest way to get a reasonable frame but maybe im wrong?

    i then plan to swap out the x and z axis to linear rail (off ali) for around 150£

    as far as motors go i am thinking 60BYGH401-03 because they are cheap and seem to have reasonably low inductance along with this i am thinking 48v and CW8060 drivers but maybe there are better available?

    i dont know on the controller yet so some advice would be awesome

    spindle. i don't really know with this one, i have read some good things about the G-Penny 2.2kw one (https://www.aliexpress.com/item/3225...c00pATS93&mp=1) it seems cheap ish and gets pretty good reviews. at the same time i don't know how good it really is so maybe someone can recommend me something better.

    i have found multiple options for a few things and would like to ask which is best

    spindle- they are all around the same price but with different vfds but which is the best?


    steppers i am thinking nema 23 and these are the options i have found which is the best?

    https://www.welectron.com/JMC-iHSV57...ed-Servo-Motor (this one comes with integrated drivers but is about the same cost as the other with a CW8060 driver)


    i am thinking of going for a way over kill driver to give me head room for new/ more powerful motors

    options are the cw8060 https://www.aliexpress.com/item/6127...archweb201603_

    or cheap out and get some https://www.aliexpress.com/item/3291...c00DrQIm1&mp=1

    my question is what is the best cheap stepper right now?

    as far as voltage goes i am thinking 48v but is this too high?

    ohh almost forgot. i plan to cut mostly aluminium and some occasional Delrin

    let me know if you need anymore details thanks for any advice in advance Tank!

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice