ACRO 1010, Y2 runs opposite of Y1

As the title shows, My Y axis motors are running in opposite directions.

Ive been on the documents page, I see for Nema 23 motors you need to invert the wiring for this issue. But it doesn't say that for the Nema 17 steppers.

What am I missing here?

Currently setting up the blackbox controller. Everything is wired and I have reflashed for the Acro 2 axis firmware.

 

Im going to rewire Y2 opposite of Y1

 

That fixed it. The Document 3.2.3 should have Nema 17's in the header along with the 23's