Kind of lost on how to set homing! I’ve browsed through several topics after a keyword search and looked several times at openbuilds documentation. Probably a little overwhelmed honestly and probably missing it I’m sure. I’ve looked at grbl settings tab but not fully grasping things. Maybe a quick rundown on settings I need in layman’s terms.
1) install and wire switches as shown in the LEAD1010 Wiring and Software video 2) on Grbl Settings tab make sure you have Limit Switches Installed ticked on (just right of the machine selection dropdown, also shown in the video) That's all it takes
5min40sec+- shows limits wiring and installation 59min+- shows machine selection 1h00min20sec+- shows limit switch tick
Thanks again! You’re going to get tired of me! Just hadn’t saved to firmware after turning on the limit switch installed .
