Separate names with a comma.
Some features disabled for guests. Register Today.
I liked the inner tracks of the C-beam because as you say, it saves space. The main reason was it’s more likely to keep dust & shavings off the...
Hi there I’ve used standard 8mm pillow bearings, which hold really nicely onto the T8x8 screw drives - the bearings in the standard nema23’s do...
Hi Peter After I do the homing cycle, the co-ordinates go to (X: -812mm,Y:-812mm Z: 2mm) When I set all to Zero & save it, Its works fine, but...
Kenneth Witthuhn published a new build: Based on the popular C-beam / V-wheel design, with the largest available work area, relative to machine...
Spec: Machine size: (1110mm x 1110mm @ 485mm high) Work area parameters (X: 813mm Y: 813mm Z: 90mm) - 105mm Z-travel Carbon fibre gantry plates...
Thanks Peter - for your help - I will post the serial log tomorrow- when I’m back @ my office (where the machine is)
I’m using (T8x8)lead screws - with the nema23 positioned @ the back of the machine. What if I invert the signals to the nema23’s & invert the...
Hi peter - the problem is not from the g-code file - this persistent problem is happening prior to the sending g-code file - before I even load...
Thanks Peter I’ve done this several times - but I always have the same problem - I always have to revert to turning of off the (soft-limit). The...
Gnea/grbl - explains it all - thank you for your very quick response! The reason for my frustration is - I want to use the (soft-limit) to protect...
Hi folks I’ve made a few workbee style machines & I’ve always used the BlackBox controller which - I find is very robust, easy to assemble, setup...