Separate names with a comma.
Some features disabled for guests. Register Today.
Hello again... Well, there was a little clarification about the problem... The actual freezer is actually accurate enough... The problem is that...
Hello, although it's late, I could always make the adjustment ... and surprise .. I had a digital callipers ... x.xxx mm and with a little...
Ok i see what you write The change will clearly make a huge difference, what effect does it make, I can not conclude it's going to be tested ... I...
Ok I have read and seen something about the phenomenon of backlash ... and apparently a bigger problem when making round holes ... I will go to...
Hello Thanks for your support! First: Scotty Orr comes with a suggestion ... I do not know which vertion of Fusion 360 you are using, but that's...
TO cncmd: Is tried and it's spot on. Sharp corners and everything perfect ... But I doubt that it's hardware ... so I've ordered a gearbox for the...
a little follow-up ... in the match, I have switched to mach3 ... still the same problem ... but in mach3 post processor I can choose " Radius...
Hi! The suggestion has been before, just I can not figure out where to change the parameters in fusion360, it's probably a bit over my head,
It is a 100% fusion360 project
Hello friends... Sorry, I first respond now, I've been away. + I have done all sorts of experiments... Now I have taken a picture of the problem,...
Hello Thanks for your quick response ... I had the same thought. But I can not find this feature in fusion 360. I can not help thinking that it...
hello ... I'm new here and the question has probably been asked before, but I can not find the answer. so here comes my problem. I have built a...