Separate names with a comma.
Some features disabled for guests. Register Today.
Rats. I'd hoped there was another (many) trailblazers like me who had tried it, but had perfected it, which I did not. You see a while ago I tried...
As 98% of my cutting is .032" thick aluminum sheet, my bit goes through the material and into the spoil board every cut. So that idea wouldn't...
Yes my 50's era Atlas 10" has flex, I understand. I should have phrased my question better. Considering the rest of my C-Beam is basically stock,...
I have a fairly stock C-Beam I use to primarily cut .032" aluminum sheet. I use a coolant mist/spray to do it. I currently have the standard 3/4"...
Not seen in the photo, my current router clamp, is that there are 4 black corner connectors holding it, 2 on the top and 2 on the bottom. Would 2...
I see how you might have done that Stwspoon. Thanks for the idea, I like it. There is 20mm under the z column I can get. Attached is a picture of...
6 years since I built my C-Beam, back when this thread first started 55 pages ago. I've done a few minor modifications to it but most of the...
Thanks Rob. I did not know Fusion 360 is free for hobbyist use. I assume design drawing is done and cut paths created and gcode generated all in...
Built a C-Beam in 2015 and have been using it since about every 2 or 3 months to make stuff for my many other hobbies. Have had lots of fun along...
Thanks Gerrit, will do.
Went to test what David discovered in his last post. Tried to type G28 Z0 in the settings field for Spcl Posn 1 and once again as I previously...
Thanks Gerrit. I did take note of the G28 Z0 suggestion. It would seem that G28 and G30 will do what I want/need, I just couldn't see it. That's...
I believe it was David who suggested using G28 to go to a known position. I never set G28 to anything other that 0,0,0 because I was under the...
Answered my own question. GNEA 1.1 is the latest version of GRBL. I'm confused about upgrading to 1.1 from V.9. Will I have to reconfigure how...
What is Gnea 1.1? Yes I realize the text you see when you hover it is the hint yet depending on what you put in the field in the setting page the...
Yes Gerrit, thank you. I'm certainly not complaining. If I knew how to do the coding I would probably add the features I want and share them.
David, setting G28 isn't hard to do but another step. G28 and G54 are set to machine 0,0,0 by the home command. Going to G28 or G54 then hits the...
Thanks guys. G53 was the missing key. I was getting confused by the G90/G91 and didn't see G53. Here is was is working for me know. First as...
I have a C-Beam. Running Grbl v.9 and GRBL Panel 1.0.9.13 Trying to create a macro that will always move the table forward, center the x and...
I've been trying to figure out how to do the exact same thing with out riggers on the cutting board. A few pictures are worth a thousand words....