Separate names with a comma.
Some features disabled for guests. Register Today.
This is my final settings as a whole. I am very happy that I switched to clearpath servos. I think the steppers were ok for starters but if you...
Here is the update that I hope will help out those that are trying to use the clearpath SDK servos on Arduino using grbl for g code. I took out...
ok I got movement. I am real busy with caregiving for the wife right now, but I was able to get the one motor I was testing to work. I will finish...
ok I tried changing $5 to 1 and that didn't work so I changed it back. here is my $ settings. The $0 I changed from 10 because of faster read time...
ok a little more news, I called teknik & talked to Mark. I had reversed A+ and B+ as step and dir. That bit of info is in the fine print on page...
the sdk series has only 1 mode and all the negatives are externally soldered together and then connected to ground. I don't think you can connect...
Well it still doesn't work. page 48 says that the Input A+ and B+ are both automatically configured internally. I connected enable + and - to...
I do believe you are correct, I just have to think a little longer. ha ha I am sure glad there are people like you guys to help us out.
Yes I have the sdk series motors. Looks like the blue is enable + and the HLFB is ignored and the input A and B positives are direction and...
Don't want to be dense, so as I understand it input A will be a positive and input B will be a ground and the others just not connected at all....
The video from teknik shows using pins that are not designated the same as arduino config.h but with no explanation for a config.
[ATTACH]
yup sure did many times on page 45 and others including some teknik videos. the only one that shows wiring is the one video and it just uses the...
But the clearpath servo has an extra wire, HLFB+, INPUT B+, INPUT A+ ENABLE, and 4 others that all go to ground. And these are separate from the...
What controller are you going to use? I would be interested in how to wire it up etc.
What controller did he use? A ny other info would help me a lot as I am trying to finish my upgrade to clearpath servos but having trouble finding...
Ok I see you have the clearpath servos. looks very nice. I am just trying to finish an upgrade from steppers to the clearpath sd servos. What...
Has anyone figured out how to wire a clearpath sd to arduino using grbl. I assume you have to redo the config.h to allow for the differences in...
noise doesn't go thru a solenoid switch either especially if it is 24 volts etc. but if you had read the previous you would have seen that all...
I changed a few things and now it all works as it should. It homes and backs off the switches the correct amount. I fixed it before I got on to...