Separate names with a comma.
Some features disabled for guests. Register Today.
I will check it out and compare with my edit..... I changed the reference in the post processor. I believe it use peirce offset and I changed it...
I ran into a similar issue, I would get paths removed errors or when pierce height was set in the tool settings they would get ignored. I had to...
This is my Plasma table build. 1. purchase and build openbuilds lead cnc kit complete with black box 2. purchase Torch height controller(sf-hc25g)...
Best idea yet..... I know i use the prev version of black box and it works great.... At some point i may try x32..... I would like to not only use...
Find pinout of motor driver online. Then figure out which pins are dir, step and enable. Verify if enable is actually used or just shorted(i...
As an edit, i also believe that most boards that use dual drivers for z or y for example do it electronically. Of the top of my head thinking you...
Depending on board layout physical change may be easier, however you can also edit pin assignments in grbl.
Someone can correct me if im wrong. But i believe those machine options are just preset for easy fill in of dimensions and perhaps home...
Do you have acess to the original config.h If not Id hit $$ on control panel with original controller. Take a pic. Then $$ again with black box...
Did you get the alarm situation ironed out...... that can be related to a Homing setting as well. Its letting you know machine hasnt been home...
Did you modify homing sequence..... the default i believe does not correctly with corxy..... default as i recall is x&y home simultaneously, where...
What is the machine you bought?
Def sounds like grbl and the machine are set up oposite. One is Cartesian and the other as corexy.
Correct. In my fusion 360 post I insert an M code forfeed hold after fire command is issued and then my THC sends back a resume signal to BB...
Yep
Which firmware version are you running? There a few you can reflash. In firmware I switched door open pin with resume pin. Then connected my...
I just saw that I was tagged, did you get your automatic resume figured out?
just thought Id do one more update, first off using less than 12v on sf-hc25g in the NC connect section was causing issues. I elected to use a 24v...
Jason Moore published a new build: lead machine plasma table with Black Box, and Torch Height Control Read more about this build...
wouldnt it be more reliable to use drivers that can run at 36v. and either use step and dir from black box if you want, or sorry to say another...
