Separate names with a comma.
Some features disabled for guests. Register Today.
It was just the preview messing me up. Ran the code offset +5mm on Z and it looked good. I was able to cut some carbon prepreg with a drag knife...
That's what I see as well, but when I run the "simulate" process the tool tip jumps to thee points on the circles rather than following the...
Attached is the NC code from Estlcam. It looks like it is not forming circles at all even though the "simulation" shows the circular tool path?
I'm using Estlcam to create NC code and controlling my Workbee 1050 with OpenBuilds Controller. The file in question is a series of 9 "donut"...
Thanks for the tips. I'll post some results when I get stuff cut.
Alex, I plan on cutting some thicker (5mm) carbon plate with my WorkBee 1050. I've made an aluminum base plate with plastic sides that I'll...
I calibrated the Workbee using some of the procedures shown. I have a 0.010" graduated scale so I used 20" (508mm) on the Y axis and 10" (254mm)...
I seem to have an issue when I translate a part from Solidworks DXF to Estlcam to OpenBuilds Controller to my Workbee 1050. Things seem to be...
I figured out what was wrong. I had the motor wires in the wrong order. I had WiFi issues and could not watch the wiring video in my shop. I...
No problem, thanks for your help. I'll see what I can find out but again, this part in not my forte.
I have not changed the motor current from the factory setting?
One Y motor is just cycling with no movement? The X is locked and has a red LED?
The motors appear to be locking up, making noise in a cycling pattern intermittently. The jog commands don't seem to do anything to the motors?...
The motors appear to be locking up, making noise in a cycling pattern intermittently when I apply power? In the trouble shooting tab I can see...
I will check that out. Does that explain the noises and LED flashing in my linked video?
[15:08:08] [ connect ] PORT INFO: Port is now open: COM3 - Attempting to detect Firmware [15:08:08] [ connect ] Checking for firmware on COM3...
Mark, I am using the OpenBuilds Control Software. I'm not sure how to copy the Grbl settings? I can't seem to copy/paste from the software...
Not sure this is where I should post questions but... I'm new here and just finished up assembly of a Workbee 1050. Everything went well...