Separate names with a comma.
Some features disabled for guests. Register Today.
""
Thanks David.
This morning I started a new project in oak 220x550x35mm. I had already put the plank on the table yesterday and applied cleats. I also had...
Hello, Or a broken wire, that has happened to me twice already, but I use my machine 6 days a week and therefore very often use the Probe to...
I just installed Control on my other computer and it opens flawlessly. That means something on my computer is blocking Control from starting but I...
Hello Peter, It was by no means the intention to blame Control for not starting up. I think it's a fantastic piece of software that is made...
Hello Peter, After another new version of Control, I'm wrong again. I can't start Control again. This morning when I started up the computer I was...
hello all, This was a very nice project but it took a lot of hours. In total, including the finishing, the project took 18 hours.
Because this slice of a tree trunk is not flat at all, I had to make it flat first. I put it on my CNC table and tried to get it as flat as...
Hello Craig, Thank you very much for your response. I think I'll have to switch to the newer version over time as well. I was always taught never...
Hello Craig, What version of inkscape are you using there. I myself am still working with 0.92 although I know there are newer versions. I just...
Oke OK, I'll try that then. every morning before I go into the shed I always check my mail so that should be fine. Thanks for your reply. Yours...
Hello peter, That may be the cause, but I always only install 'for me'. I have now turned a complete 3D workpiece with the machine and everything...
Hello Peter, the machine is working again. The calibration was also as it should be. I still don't understand what went wrong yesterday. I will...
Hi David, This morning I restarted the computer and now I find my icon in the hidden icons again. It's working again and I'm happy with it. If it...
Hello peter, Thank you for your answer. This morning I restarted the computer and now the icon was back in the hidden icons and I was able to...
This morning I started a 3d workpiece and turned a contour first. Then I started the rouching and both operations went fine. At the end of each...
