Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Search Results

Search Again
  1. Pat Deyo
    Post

    Interface Connection Issue

    They replaced the item under warranty, before it finally worked
    Post by: Pat Deyo, Jul 31, 2021 in forum: Interfaces
  2. Pat Deyo
    Post

    Interface Connection Issue

    Ok, I've posted three emails to the contact-us form in the last couple of days and have had no response.
    Post by: Pat Deyo, Jan 28, 2021 in forum: Interfaces
  3. Pat Deyo
    Post

    Interface Connection Issue

    Just looked at the bottom of the board and I see no burned IC's. Just wonder.ing... since I have always used the USB Port could the unit have...
    Post by: Pat Deyo, Jan 28, 2021 in forum: Interfaces
  4. Pat Deyo
    Post

    Interface Connection Issue

    That is the only light I can see. I've included pictures of the unit power on. All I can say is that the Blackbox worked before doing the...
    Post by: Pat Deyo, Jan 28, 2021 in forum: Interfaces
  5. Pat Deyo
    Post

    Interface Connection Issue

    Yes, the fan is on and the green light next to the power switch is on
    Post by: Pat Deyo, Jan 27, 2021 in forum: Interfaces
  6. Pat Deyo
    Thread

    Interface Connection Issue

    I just purchased the Interface and connected as per the Instructions and it does not work. I have a Blackbox V 2.5. I check the voltage of the...
    Thread by: Pat Deyo, Jan 27, 2021, 14 replies, in forum: Interfaces
  7. Pat Deyo
    Project Comment

    Beginner Dw611 Small Dust Boot

    Is this project available for download?
    Comment by: Pat Deyo, Jun 11, 2020 in category: Workshop
  8. Pat Deyo
    Post

    OpenBuild Control V1.0.205

    Thank you for the assistance
    Post by: Pat Deyo, Jan 28, 2020 in forum: Control Software
  9. Pat Deyo
    Thread

    OpenBuild Control V1.0.205

    I am using OpenBuild Control V1.0.205, and wondering if there is a way to have the program open in full screen so that the program opens...
    Thread by: Pat Deyo, Jan 28, 2020, 2 replies, in forum: Control Software
  10. Pat Deyo
    Thread

    X Pro Controller for 2.8 amp Stepper Motors

    I am using a X Pro ver 4.0 to run the four 2.8 amp stepper motors. In order to get the motors to run a full capacity the voltage on the board is...
    Thread by: Pat Deyo, Apr 6, 2019, 0 replies, in forum: Controller Boards
Showing results 1 to 10 of 10
Search Again
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice