Separate names with a comma.
Some features disabled for guests. Register Today.
ive used an 8mm bit to cut a 80 mm circle in 3mm acrylic, with a speed of 22600, I slowed the feed rate down to 1800 as it seemed a bit too fast...
thanks for the reply. I have fixed the board down and managed to cut a small circle. but the edges are really rough, ive used an 8mm bit to cut a...
Any tips on the best way to hold down the spoil board on a cnc router, ive tried cutting a sheet of perspex and the sheet seems to run up the bit,...
I have the ox cnc machine, how accurate can I expect the Z axis to be? and how do I calibrate it? when I run a job the first cut always seems to...
I bought an ox cnc machine from ooznest, and it didn't come with stop switches and the homing cycle is disabled on the controller, is running a...
ive cut a few simple things on my ox cnc machine, and I seem to keep getting the same problem, cuts along the X axis seem fine, but the cuts along...
between cutting depths the tool raises and then lowers again, but it dosnt lower into the same position it where it rased its offset slightly and...
how do I work out the speed and feed rate if all I know is the cutting diameter and material I want to cut?
how do I download that other post processor?
Thanks for the reply I'll try al that out tomoriw and see how I get on
>>> G1Y0 is there a problem with this bit?
I don't know if this is anything to do with it but that helps a little but the programme still pauses with the pen into the material heres my...
I'm importing files to the universal gcode sender from fuision360, ive not used cutting bit yet, just using a ped until I get the hang of it. ive...
thanks a lot that helped, I have however ran unto another problem, the machine has stoped running, when I click in the controller to move the...
Ok sounds good I'll try it out, thanks! Is grbl the processor I want to use then? And inn guessing that will be an option on fusion 360
sorry what do you mean post proccesor? I'm using universal gcode sender
ive tried to upload a simple desing from fuision360 to gcode, ive followed all the steps for cutting lines, I think and a get errors when running...