Separate names with a comma.
Some features disabled for guests. Register Today.
Greetings Paul, I would appreciate your input with respect to KL-800A Spindle and VFD unit that you purchased ...I would like to up grade from...
Hi Kevon, Thanks for responding, I appreciate the input... I am routing out wood signs, pine, cedar oak, Maple and machine grade MDF etc.. I...
Noted, Thank you just the same.. Sorry that information did not stay organized when I posted it - I meant for the comparison to present in two...
Rick, One final question... you have a technical acumen that I lack, for the sake of maximum benefit, for the Ox Metal CNC that I have, which...
Right...sorry, I should have picked up on that... I will replace the TR8*8 with the TR8*2 When I install the heavier spindle from UGRA CNC....
Greetings Rick 2.0, Thank you for responding, Sorry, I should have included that detail in my Build Spec, this is what's installed on the Z...
Greetings, I would like to upgrade my OX Metal CNC Spindle From: Quiet Cut Spidle, 300W 12,000 RPM as stated the my build spec below: To: GMT...
Succinctly put Kevon...hopefully somebody who is embarking on a build will run across these comments and find them to be of value as " best...
Greetings, Blind Moe, Kevon That's the thing... as a novice your trying to navigate building one of these machines without a frame of reference,...
Greetings, I wanted to reach out and thank everybody on this post, I have to say that these old posts still have value, I built an OX metal CNC...
Currently I am using the XPRO board, which has been flawless, I recall reading about being able to check for G code conflicts somewhere.........
Greetings CNCMD & Thanks for responding, You're right it was a soft limits issue on the X axis .... what was throwing me off was that the...
RE: Machine Type: Ox Metal CNC / Machine dimensions from rail to rail are: X=946.15 Y= 1492.25 / Z 54.992 XPro Board Greetings, I am...
These are your points of contact on the switch +NC NO C - Below in the drawing the (+NC NO C -) is the same order as the pins in the drawing if...
Hi Deano, LED does not make a difference ...The principle is essentially the same, my diagram shows shows the pin order and where to run the...
Greetings Deano, See attached diagram.. it has notes for the pin out for the switches ... look at the bottom of your switches with a magnifying...
Issue: Spindle cuts out after starting a file Greetings, I am hopping that somebody can respond to this... Trying to set up and calibrate my...
Greetings Jeff & Donald I am very new at this as well... Suggest that you download and install Universal Gcode Sender, the interface is pretty...
Post Removed