Separate names with a comma.
Some features disabled for guests. Register Today.
Thank you for your Help! All is fixed.
yes i updated that setting as well. The spindle now comes to full stop is the only thing that changed the variation w the rpms remains
On my initial VFD setup but i think it would be a good to go back through it. Also i am going to check the voltage at the other end going into the...
Ok solved 2 of the three issues. pushed the reset button on the BB instead of relying on the reset from the control program. Fixed the PWM at...
So yes after updating the Grbl setting of max spindle speed to 24,000 reset back box. Using the menu item in control for 24,000 or 12,000 all the...
Ok so i imported backup and that put me back to no voltage change. Reset Eprom everything good again. SO i decided that I would just update the...
HERO STATUS! Ok i am getting voltage change when tool is activated and PWM LED is on. Can i load the saved GRBL settings? We are back to the...
Well looks like PWM is the current issue. The PWM LED never comes on. Is it fried?
[ATTACH] [ATTACH]
The Light is Bright when commanded dont notice any deviation. But the light only comes on when the tool is commanded. I think power is good. How...
Yes I also made sure everything else was working all axis move and the coolant can command on and off
Really not much. Unmounted the BB from the back of the Machine. Cut the wire ties on the wire loom to get the signal wire to the VFD away from the...
Not sure what has happened but now i get no voltage change when I command on the VFD from Control. Getting .3 v send M3 S24000 no increase in...
$0=10.0 ; Step pulse time, microseconds $1=255 ; Step idle delay, milliseconds $2=0 ; Step pulse invert, mask $3=4 ; Step direction...
i just upgraded my BlackBox from 4x to X32. Previously my VFD operated perfectly. Now the spindle will not completely shut off with tool off...
So I made progress. It is the Z Axis Limit switch that is causing the issue. The limit switch is normally mounted on the bottom of the Z Axis...
Any updates on this I have the same issue with my New XYZ probe. When the machine is trying to zero Z the green light comes on when it touches but...
I just reset to factory and renetered all the settings and it works fine now.
I am adding the Z Mod to my lead machine. I have run into a spindle mounting issue. I have one of Chris's great spindle mounts so it is machined...
Huanyang VFD 220v 2.2KW Water Cooled Spindle I have been over the settings and I just can seem to find the one for this. The spindle will only...