Separate names with a comma.
Some features disabled for guests. Register Today.
This cable solved all my EMI Problems..... They aren't all the same.......
Fixed, Re-flashed it with Arduino
I do have another Brains Board, remember... they sent me two of them
How do you clear the EEPROM?
Reinstalled the Open Build control panel and update, reinstalled the driver, changed the com port...ect. I think it got wiped...
Did the reboot and reset button, same. connected to it with grbl panel and settings were empty
Had a power outage with the cnc in operation. It now boots and connects but there are no GRBL settings or movements. I disconnected all but the...
OK, will do. Thank You
Disconnected all but usb, same thing, firmware gone. I did the same on a different PC, firmware gone. Drivers present and enabled on both PC's Red...
Any Ideas??? Was acting funny... wouldn't retain any Grbl settings then I got this......
Thank You, Lots of trial and error with Fusion 360 and wooden prototyping. OK, I saw that doc. So I guess I have to open it up and look at the...
Thank You Are the Limit sw. default 5v? or 24V? I need 5v , 2 wire. It's not in the doc as far as I can tell. Read the whole thing and all the...
Hi, I received my BlackBox last week and to my surprise it was completely assembled. I was curious as to what the default stepper and limit...
Looks good, That thing is a tank. You need a good mister for aluminum and avoid slotting when possible. My mister is similar to the one in this...
I never had much luck with glue, and that stuff sets in 5-12 minutes, Yikes! I would make a mess of it
And sometimes what looks good on paper doesn't look to good in the real world......
Thank You for your Service Sir
Sure, Post it. I think the screw in the middle would drive the rails with more equal horizontal force. You could do the two 2 by's and join them...
I guess the lead screw will be on the top? Looks good Maybe split the 2x6 like this?