Separate names with a comma.
Some features disabled for guests. Register Today.
I've looked up the data. The Motech MT-2303HS280AW steppers in my OX are rated up to 2.8Amps. The driver chips in my xPro controller are rated at...
To confirm the problem I ran the Celtic Weave project again. This time the result was worse with only a groove routed left to right! However this...
I've just had a chance to try another Celtic Weave using Aspire software. When it was designed and simulated, all seemed well but when I came to...
I just read Scotty's comment. Earthing is something that I'd like to look at. When I was adjusting the Y motor current a few hours ago I noticed...
I found I was able to tighten the router clamp so it may well have moved a bit. That may explain the problem I had with dimples being routed...
I decided to do a very simple test which consisted of routing a 20mm deep circular hole, rectangular hole and triangular hole into some soft wood....
I wanted to make 4 dimple matrix panels in order to fabricate a 4 sided box. I only got to the 3rd panel on one long piece of wood. I will try it...
Thanks for the reply. In the case I mentioned, of machining a matrix of dimples, I successfully did two sets of them and on the third, things went...
Hi, I'm new to the Ox but I have got it to work. However when I do more complicated projects the machine appears to skip steps. For example, when...
I'm converting the file to Grbl(mm) gcode format. I sometimes wonder if there is a problem with the format?
Hi Alex, I have used my Ox router on some small projects but I consistently get problems with more complicated ones. When attempting to route a...