Separate names with a comma.
Some features disabled for guests. Register Today.
I am thinking I will replace this board with a woodpecker cnc board. Are there any better low cost options ? Nikki
After doing some testing with a led when i run m3/4 the DIR pin turns on is that normal ? I was assuming it should be spindle enable
I have sent the manufacturer a email asking for any info on the board i have a feeling its not switching because of a incorrect grbl pinout. Ill...
Thank you I have just tried putting a multi meter on the 4 pin phoenix connector putting the firmware in laser mode and sending a m3 command but...
Please could some one tell me the pinout for the green headers I have looked all over the internet but not found any info. Thanks Nikki [ATTACH]...
I have found my problem. because i am use to using octoprint i forgot to check if the g code sender was at zero when i reset it to zero it works...
Hi i have changed the config.h file for homing corexy. when i don't home it and send the g-code it is still moving to the maximum extremes of both...
I have built a corexy drawbot like the axidraw but i am having a few problems getting grbl to work correctly. Everything is working but after...